Kahe Volvo Penta D6 mootori ja DPI veojala 48 kuu hoolduse varuosad

Ask a boat owner what an autumn engine service involves and the answer is often “an oil and filter change”. That matters, but it is only part of the job.

The photo shows all the parts that went into the 48-month service of a motor boat's two Volvo Penta D6 engines and DPI sterndrives. As you can see, the oil and filter are just two of many items.

Oil and filters

Engine oil and the oil filter are changed at every service, and on the D6 the bypass oil filter too. There is a good reason to do it in autumn: used oil contains acids and moisture that do damage inside an engine standing idle all winter. With fresh oil the engine winters much better.

Fuel system

Fuel filters and the water separator collect water and dirt over the summer. It also pays to leave the tank as full as possible over winter so less condensation forms.

Cooling and the seawater pump

The seawater pump impeller is a wear part. If an old impeller breaks up, its pieces can block the heat exchanger and the season can end with an overheated engine. A new impeller costs little compared with the repair. The condition of the coolant is checked during the service too.

Belts

Drive belts age even when nothing shows on the outside. If a belt snaps under way, the boat is often left without charging and cooling.

Sterndrive

The sterndrive matters as much as the engine:

  • Drive oil: changed, and at the same time checked for water. If there is water, find the cause before spring.
  • Bellows: made of rubber, they keep water out of the boat and the drive. Drive bellows are replaced at a fixed interval even when nothing shows on the outside. Through a damaged U-joint bellows seawater quickly gets into the drive, and that repair costs more than several services put together. A failed bellows can even sink the boat.
  • Anodes: they protect the drive and engine against corrosion. In the brackish water of the Baltic Sea we recommend aluminium anodes.

Why a 48-month service

The Volvo Penta maintenance schedule has jobs done every year, jobs done every second season, and jobs with longer intervals. The four-year service is one of the biggest: on top of the annual parts, the slower-wearing ones are replaced as well. The exact list depends on the engine and drive model, so check your boat's maintenance schedule or ask us.

For example, the Volvo Penta D6-380A-G service protocol sets out the following. Each job is due when either the time or the engine-hour limit is reached, whichever comes first.

IntervalWork
Every 12 months or 200 hReplace fuel pre-filter and fine filter, clean seawater filter, check belts, power steering and trim oil, coolant and antifreeze mixture and exhaust hose, check engine software version
Every 12 months or 400 hCheck anodes, lubricate propeller shaft and pivot pins, check drive bellows
Every 24 months or 200 hReplace engine oil and oil filters, air filter, and drive oil and filter*
* – we still recommend doing this every year
Every 24 months or 400 hReplace seawater pump impeller
Every 24 months or 800 hReplace drive exhaust and U-joint bellows
Every 48 months or 800 hReplace belts and power steering and trim hydraulic oil, check belt tensioner and idler pulley bearings
Every 48 months or 2000 hReplace coolant and compressor oil, overhaul seawater pump

In the four-year service all of these jobs fall due at once. That is why the photo shows bellows, belts, impellers and anodes alongside the oil and filters.

Getting the engine ready for winter

After the service the engine also needs to be prepared for winter. The Volvo Penta manual sets out the following:

  • Seawater out: drain the seawater from the heat exchanger and the charge air cooler, and loosen the seawater pump cover. Water left in the system can burst parts when it freezes.
  • Frost protection: on land, run the engine with a mix of 40% coolant and 60% fresh water through the seawater system. Collect the mix that comes out of the exhaust and take it for disposal.
  • Coolant all year round: the right coolant protects the engine against corrosion, not only against frost.
  • Dry engine compartment: pump out the bilge, dry the engine compartment and leave good ventilation over winter so mould and corrosion do not form.
  • Wash with care: when washing the engine compartment, do not aim the washer at the alternator or the bellows. After washing, check the hoses, bellows and wiring.

What a BMG technician does during the service

A BMG technician does not just swap wear parts. He works to the Volvo Penta service protocol and service manual, so every job is done at the right time and in the right way.

Besides the engine, the technician checks the rest of the boat's equipment against the Volvo Penta Health Check protocol: batteries, cables, hoses and pipes, fuel lines, seawater filter, air filter, belts, anodes, and oil, fuel, coolant, seawater and exhaust leaks. Engine and drive are also checked by sound. For each item the technician records whether it is fine, whether a repair is recommended, or whether it must be fixed straight away.

Engine diagnostics are done with the Volvo Penta VODIA diagnostic tool. It reads out fault codes, checks the engine software and confirms that there are no open service, quality or recall campaigns for the engine. If there are, they are carried out at the same visit.

The service is on record: Online Service Protocol

An authorised Volvo Penta service company such as BMG Power Systems fills in the Volvo Penta Online Service Protocol for every engine it services. It is stored in the Volvo Penta extranet, where other Volvo Penta dealers can see it too. The boat owner can see the engine's service history in the Volvo Penta Easy Connect app.

A properly completed Online Service Protocol proves that your Volvo Penta engine has been serviced properly and regularly. When you sell the boat, it is a strong argument that raises the market value of the whole boat.

Why autumn

In spring every boat wants to go in the water at once and workshops have queues. In autumn there is time, and no rush for parts either. If the service turns up something bigger, you have the whole winter to fix it.

What we offer

Volvo Penta service kits are available at boatparts.ee for D6, D4 and D1–D2 engines and many Aquamatic drives. One box holds the right filters, gaskets and wear parts. If you would like the work done by Volvo Penta trained technicians, write to service.ee@bmgpower.eu. If a service kit does not fit your needs, ask us for individual service parts as well.

For laying up the boat, see also our autumn boat care tips.

Mootorihooldus, Talvitamine, Volvo penta